The first part of installing roof flashing to a stucco wall is to gather the necessary materials.
Flashing roof stucco house.
The roof flashing cannot be installed on the outside of the stucco and counter flashed.
Slip the wall leg of the weep screed behind the existing paper.
The soft aluminum base conforms to most metal roof panels.
Wall to roof flashing.
The water that does penetrate behind the stucco will then be trapped there or worse forced down the inside of the walls and ceilings possibly causing damage and mold.
Lay 2x4 blocks on the roof to set a consistent height for the weep screed flashing.
Luckily it is not that complicated to install roof flashing against a stucco wall and it can save you a lot of money in the long run because your roof and walls will not be as susceptible to water damage.
After removing the stucco slide a 2x2 galv flashing up behind the paper.
Now the water that is running down the wall inside the stucco will exit the stucco onto the flashing you installed not behind it.
This flashing provides protection for pipes cables conduits and wires.
Typically made of aluminium or galvanized steel flashing is any material used over joints in your walls or roof to prevent water from seeping through.
Wood siding material choices installation vinyl siding stucco exteriors building trim exterior caulks and sealants exterior building adhesives and choices and application of exterior finishes on.
Up to 5 3 4 in.
Applying flashing to a stucco roof or walls requires both cement and nails as well as caulk or more stucco to create a water tight seal.
Materials for installing flashing to stucco.
Check out our recommended tools right here.
Wall flashing roof wall flashing errors and causes of leaks and roof wall intersection flashing to prevent leaks or water damage.
After the roofing is installed slide the flashing down to the roofing material and seal it well.
This is usually an l shaped piece of metal that spans the gap between the stucco wall and the roof in most cases.
