Start by making an outline on the siding where you want to position the ledger board.
Flashing house siding.
Building siding flashing finish details for building corners use overlapping 1x4s or 1x6s at outside corners or use 5 4 stock for a heavier look.
Use a felt paper spline wrapped around the corner and extending 6 inches beyond the corner board to protect the joints where the siding meets the corner boards see figure 1 5 at left.
Traditionally the flashing was installed and hidden under the siding.
When it comes to the deck a strip of flashing is brought down the wall of the house and over the top of the ledger the piece of dimensional lumber attached to the house at the edge of the deck.
This flashing should not be seen for it disrupts the architectural balance of the.
It can have the look of wood siding without the ongoing work and expense.
But unlike fiber cement siding wood is almost sure to rot.
Vinyl siding is designed to withstand weather and resist moisture damage.
Lots of materials can be used for flashing.
Snap a chalk line cut out the siding and tack up the ledger board.
However in most instances step flashing should be installed behind siding.
When it comes to flashing siding corners many builders simply use a 1x wood corner.
The water table should overlap the foundation by about 1 in.
In certain instances flashing may need to be installed on the exterior of siding.
It is at the back of the porch roof where the roof meets the house siding.
Many types to choose from.
Many traditional homes have a wide board called the water table that runs around the house along the foundation and supports the first piece of siding.
And when those corners start to decay they become.
It is ideal for siding applications from new home construction utility buildings planters dog houses and other remodeling or do it yourself projects.
That is fine but it must still look like the flashing is behind the siding.
Inspect the sidewall around and underneath the fascia and inside the house for signs of moisture damage and repair any rotted areas.
It plywood siding is an all wood exterior grade panel.
Plywood siding is an all wood exterior grade panel.
And be capped on top with either a preformed metal drip cap or a custom flashing installed under the sheathing wrap.
Add felt if needed before nailing the new wood on and prime the new wood on all.
It is always recommended to install step flashing behind stucco dryvit wood panel lap siding vinyl siding cedar shingle siding etc.
Then slip flashing behind the siding covering the top edge of the ledger.
If the kick out and step flashing can t tuck behind the siding screw on cap flashing to cover it then caulk along the top.
Plywood siding features a rough sawn textured face for a beautiful rustic appearance.
Make the outline large enough to include space for the deck boards on.
